Chapter 5 Setting of Embroidery Parameters
5.2 Instruction of Some Functions within General Parameters
There are brief introductions of the parameters in the appendix 1. At here, we will
introduce some functions used in embroidery.
5.2.1.
Cyclic Embroidery Function
This function is to increase the embroidery productivity.
When the parameter “To Do Cyclic Emb.” is set as “Yes”, the cyclic embroidery
function is activated and the icon
will appear in the main interface. If this function is
activated, the machine will automatically embroider the designated design again without any
operation when completing it.
Usually, cyclic embroidery should accompany repetition embroidery and specially made
design, and the parameter
“
Auto Origin
”
should be also set as
“
Yes
”
. Thus when the
machine is embroidering the back fabric, the front one can be replaced. After embroidering
the designated design, the frame will automatically return to the start point and the machine
will automatically embroider the front fabric again and at this time it’s possible for user to
replace the back one.
5.2.2.
Memory of Manual Color-changing
In embroidery confirmation status, the user can choose whether to store the manual
color-changing’s needle position into the color-changing order unit. Its purposes are as
follows: 1) if mistakes are found for the automatic color-changing order in embroidery, the
color-changing order can be modified with manual color-changing operation. 2) When a new
design is embroidered with manual color-changing once, the color-changing order will be set
for the design.
To use this function, the user should set the parameter “Store Manual Color” as “Yes”.
Note: the parameter value will automatically change into “No” at each end of embroidery.
5.2.3.
Brake Adjustment (A Must for New Machine)
This function is to adjust the control parameters for braking, so as to fit machines with
different mechanical characters, which is also able to change with the machine running. Thus
this function can help the machinery parts to work better with the computer. The function
depends on the parameters “Set Brake Para”.
“Set Brake Para” is to adjust the stop position of the main shaft. When the main shaft
often stops at the position below 100 degree, the user can increase the parameter value. When
the main shaft often stops at the position over 100 degree, the user can decrease the parameter
48 Owner’s Manual of BECS- 285A Computerized Control System
