Chapter 6 Memory Design Management
No.
Display
Name
Description
5
Yes
Save the appliqué setting and return.
No
Cancel the setting and return.
Help
Help informations about appliqué
embroidery
The interface display area shows the interface which is being set for appliqué. After
user sets the appliqué point, the design will be refreshed and the result will be shown directly.
5.
Click
to move the list to the position for patching. Then click
after “Add patch?” to change it to
.
6.
If user chooses to move the frame out to the offset point, please change
(which is after “To Offset Point?”.) to
. If user chooses moving the frame to a
certain distance, first change
(which is after “To Offset Point?”.) to
, and
then click
to set the moving-out distance: (2cm to 99cm) or (-2cm to
-99cm).
7.
Repeat step 5 and 6 to set all the patching positions of the interface.
8.
Click
to save the patching information and return to the operation
selection interface. Click
to cancel setting and return.
6.7 Make True Design Frame
This function is to create a new design according to the outline of the designated design.
1.
Click
in the main menu to enter the memory design management interface
2.
Select the design in the memory design image area of the memory design
management interface.
3.
Click
to enter the design operation selection interface.
Owner’s Manual of BECS- 285A Computerized Control System
59
