Chapter 2 Names of Parts about Electrical Control System
BECS-328 Computerized Embroidery Machine's Manual
8
No.
Display
Name
Management
includes operations of floppy disk and USB disk.
24
Memory Design
Management
Press it to enter the memory design management screen,
which includes “select design”, “disk input”, displaying
designs and creating new designs.
2-2 Operation Bar and Turn Shaft Button
1.
Operation bar (embroidery bar under the table)
Stop status: pull the bar to right to begin embroidery (including idle running in high or
low speed) and pull the bar to left to return (including idle running in high or low speed)
Running status: pull the bar to right to the end to embroider slowly and release to normal
speed and pull the bar to left to stop embroidery.
2.
Turn Shaft Button(over the operation bar case, on the right under the table)
To press the button to make the main shaft rotate one cycle and stop at 100
°
.
2-3 Darning Switch
1.
Thread Break Detecting Device of 3 place
There is a switch on every head of machine. When the switch is up, this head is in normal
embroidering mode and when it is in the middle, this head is in darning mode and when it is
down this head is in stop mode.
2.
Thread Break Detecting Device of 2 place
On every head of the machine, there is a darning switch, and it can be move with hand to
the up, middle or down position, but it is stop only at the middle or down position. When the
switch is pushed to up position, it can not stay at up position, and the lamp is red, which hints
that this head is in darning mode. In addition, while thread breaking during embroidering, the
lamp is automatically changed into red and this head is in darning mode. When the switch is at
middle position, this head is in darning mode if the lamp is red, or this head is in normal
embroidering mode if the lamp is green. When the switch is pushed to down position, the lamp
is off, which hints that this head is in stop mode. When the switch is pushed to middle position
from down position, the lamp will be green and the head is in normal embroidering mode.
