Chapter 3 How to Start Embroidey
“ ” before it, a password is needed to enter it.
3-1-4 How to Embroider for the First Time?
The machine embroiders according to the design in store. Before a new machine is used
normally for the first time, the computer should initialize the parameters (See Chapter 12).
Then, all patterns in memory should be cleared (See Chapter 13), Again, input the desired
pattern to memory store (See Section 3-2). After that, you can select a pattern in memory and
confirm to embroider pattern (See Section 3-4). Now, the machine goes into embroidery
confirm status. Finally, pull the embroidery bar to right to start embroidering the pattern.
3-2 Input a Design into Memory from Floppy Disk
Reading pattern into memory from floppy/USB disk can be performed both in the
operations of "Disk(USB) Management" and "Design Management".
Disk design is input using USB disk by USB port or using floppy disk by USB port. The
floppy disk is chose station. The system has one USB port, so it can be connected one floppy
disk or one USB disk. You can insert or draw floppy/USB disk directly.
Operation 1: (by the operation of "Disk(USB) Management")
1.Press "
" key (in embroidery preparation status), the computer shows as follows:
DISK(USB) MANAGEMENT
①DISK DIR
ARROW: MOVE, ENTER: CONFIRM
②INPUT
③OUTPUT(DSB)
④DEL FILE
⑤FORMAT 720K
⑥FORMAT 1.44M
⑦INSTALL LETTER LIBS
⑧DELETE LETTER LIBS
⑨DESIGN A LETTER PATTERN
⑩INPUT DESIGN FROM PC
2.Press "
“, “
" or numeric key "2" to move the cursor to "INPUT", and then press
"
" key.
BECS-328 Computerized Embroidery Machine's Manual
12
