Chapter 3 How to Start Embroidey
DISK MANAGEMENT
①DISK DIR
②INPUT
③OUTPUT(DSB)
ARROW:MOVE, ENTER:CONFIRM
④DEL FILE
⑤FORMAT 720K
⑥FORMAT 1.44M
⑦INSTALL LETTER LIBS
⑧DELETE LETTER LIBS
⑨DESIGN A LETTER PATTERN
⑩INPUT DESIGN FROM PC
3.The LCD will display the file name in floppy/USB disk, then go on according to the
prompt.
4.Select a disk pattern and press "
" key.
5.There will display the minimum design number in memory which is available (suggest
you to use), if you agree, then confirm by pressing "
" key, then begin reading. If not, then
press numeric keys to input the selected design number, if the number you input conflicts with
the number in memory, then you should input a new number and press "
" key to confirm.
6.There will be promotion: “To expand satin?”, press “
” key to select “YES” or “NO”,
and press "
" key to confirm.
7.If you select “YES”, you must input the expanded value of X and Y for all of satin
stitches of design.
8.Then the pattern file begins to be transmitted from disk to machine memory, and the
operation finishes.
Operation 2: (by the operation of "Design Management")
1.Press "
" key (in embroidery preparation status), the computer shows as follows:
BECS-328 Computerized Embroidery Machine's Manual
13
