Chapter 3 How to Start Embroidey
3-5 Normal Embroidering, Returning and Darning Embroidering
In embroidery confirmation status (the icon "
" appears), push the darning switch of
machine head that will perform normal embroidery to go to the normal embroidering mode,
and push the darning switch of machine head that will not embroider go to the darning mode,
and then pull the operation bar to right and release it to let the machine start normal embroidery.
(When you pull the bar to right and don't release it , the machine will embroider in lower
speed.) During embroidering, pull the bar to left, the machine will stop.
After the machine stops, pull the operation bar to left and the frame will return to its last
position along original path. Pull the bar one time, the frame return one needle step. Pull the
bar continuously and the frame will return one needle step after another continuously. After the
frame return 10 needle steps continuously, the frame can return continuously even when you
release the bar.( This may be different according to different machine types). When the frame
return continuously, release the bar and pull the bar to the left again, the frame will stop
returning.
The aim of returning is usually to perform darning embroidery. After the returning stops,
push the darning switch of machine head that will perform darning embroidery to go to the
darning mode, and then pull the operation bar to right and the machine head will start darning
embroidery while other heads don't. When the frame goes to the point where the frame begins
to return, other heads whose darning switches are in normal embroidering mode will start to
embroider.
3-6 Release Embroidery Confirmation Status
You should release embroidery confirmation status when you want to embroider other
patterns after finishing embroidering one pattern or to revise size ratio, rotating angle, the
repetition, figure direction, or to do the operation of "Disk Management" and "Design
Management".
Operation:
(1)
Press "
" key, the computer shows as following:
BECS-328 Computerized Embroidery Machine's Manual
18
