Chapter 7 Frame Operations
“
MACHINE PARAS
”
must be set as “N”. Otherwise this function can’t be performed in the
right way.
Operation:
(1) Press "
" key, and the following menu appears:
①
BACK TO ORIGIN
②
RESTORE ORIGIN
③
SAVE ORIGIN
④
AUTO SET ORIGIN
⑤
FRAME TO BORDER
⑥
NDL DOWN&ORIGIN
(2) Press “
" or "6" key to move the cursor to "NDL DOWN&ORIGIN", and then
press "
" key to continue.
(3) Press "
" to let needles stick into the embroidery material.
(4) Release the material from the frame. Wait until the screen shows “MOVE FRAME
TO ORIGIN POINT”.
(5) Press "
" and the frame will return to the origin point in Y direction (no change
in X direction). The screen will show “To Turn Axis” .
(6) Press "
", and the needles will be lift up and the main shaft will return to the
stop position 100°.
(7) Pull the bar to embroider.
7-8 Returning to the Stop-embroidery Point
This function is intended for patching cloth operation. After halting in the halfway of
embroidering operation, press the manual frame-shifting key to shift the frame out (for
patching cloth). After the completion of patching cloth, this function can make the frame
return to the stop-embroidery point.
Operation:
(1)
Press the manual frame-shifting key to shift the frame out (for patching cloth).
(2)
Press "
" key, the main picture appears as follows:
BECS-328 Computerized Embroidery Machine's Manual
33
