Chapter 12 Assistant Operation and Setting the Parameters
OTHER MANAGEMENT
①SHOW RANGE
②MOVE FRAME ALONG RANGE
③GENERATE DESIGN OF RANGE
ARROW：MOVE， ENTER：CONFIRM
④FRAME,THEN EMB.
⑤EMB. ONE CROSS
⑥EMB. RIGHT ANGLE
⑦EMB. DESIGN QUADRATE RANGE
⑧EMB. DESIGN TRUE RANGE
3. According to the prompt, press "
", "
" and "
" keys to complete the following
operations:
(1) Showing periphery
After selecting pattern but before starting embroidery, check the peripheral range of the
pattern.
(2) Moving frame along the periphery
After selecting the pattern but before starting embroidery, the frame will run a cycle along
the periphery for checking whether it exceeds the limits.
(3) Generating a new periphery pattern
This operation can be carried out after selecting the pattern but before starting embroidery,
which can produce a peripheral pattern of the current pattern. The peripheral pattern can be
embroidered separately.
In case user’s embroidering periphery can be achieved by embroidering the peripheral
pattern, and the peripheral pattern has a central “+” line, if the length of the central “+” line is
insufficient, the No. 99 pattern can be used for supplementary embroidery.
(4) Move frame and embroider back along the path
Operation: move the frame along the assigned paths from the current position, when meet
a inflexion, press "
" key to confirm the line path; then repeat the above operation to finish
the whole paths, you can also quit to the main picture by pressing “ESC” key; finally, you can
pull the bar directly to start embroidering, the machine will embroider along the trace in
converse direction to current position, and return to the “preparation status” automatically.
(5) Embroider one cross at current position
BECS-328 Computerized Embroidery Machine's Manual
51
