Chapter 12 Assistant Operation and Setting the Parameters
a: offset point, b: starting point
When you select a pattern and make the machine enter into the embroidery confirmation
status, the system will clear the offset point. Operations for setting offset point and
embroidering is as following:
(1)
Select a pattern for embroidering and make the machine enter into embroidery
confirmation status. (See Section 3-4)
(2)
Press "
", "
", "
" and "
" to move the frame to the starting point of pattern.
(3)
Press "
" key, the menu appears as following:
OTHER MANAGEMENT
⊗
SET DESIGN PARAS
②FRAME TO POINT (OPTIONAL)
③DESIGN RANGE,S OPERATIONS
④OFFSET
ARROW：MOVE， ENTER：CONFIRM
⑤SET POWER RESUME
⑥POWER RESUME
⑦SET MACHINE PARAS
⊗
COMPENSATION
⑨中文/ENGLISH/SPANISH
⑩TO SET CYCLIC EMB.
(4)
Press "
", "
" key or digital "4" to move the cursor to "OFFSET", and then press
"
" key.
(5)
Press "
", "
", "
" and "
" to move the frame to the offset point. In case of
needing not to set offset point or wanting to deleting offset point that has been set previously,
go to the following step without moving the frame to the offset point.
(6)
Press "
" key to continue.
(7)
Pull the bar and start embroidering.
Note: The offset point also is the point to which the frame automatically moves while
BECS-328 Computerized Embroidery Machine's Manual
53
