Chapter 12 Assistant Operation and Setting the Parameters
patching.
12-5 Setting Frame Protection when Power Off (Setting the Machine
’
s Zero
Point)(in embroidery preparation state)
The purposes of the operation are:
Purpose 1: The function of “setting the protection when power off/frame zero point” can
restore the frame position when power off unexpectedly together with the function of power
resume.
Purpose 2: The function of “setting the protection when power off/frame zero point” is to
set the base point when a pattern’s origin point needs to be saved and restored. This base point
is recommended to be any point on the bedplate, once being set, you’d better not change it and
should marks flag.
Note:
Note 1: The realization of purpose 1 is based on the available limit switch and setting
frame zero point automatically.
Note 2: The operation of “setting frame zero point automatically” or “Setting frame zero
point manually” all can set the base of saving and restoring the pattern’s origin point.
Note 3: The operation of this function can only be done with one of two operations of
“setting frame zero point automatically” and “Setting frame zero point manually”.
Note 4: Except for particular instance, during embroidering by normal operation, whether
handy frame origin memory or auto frame origin memory, one time correct setup is ok.
1. Setting frame zero point manually
Note: when meeting emergency stop because of malfunctions or something unusual such
as power off unexpectedly, etc. the machine will cancel the “setting frame origin” function to
avoid the mistakes. So, at that time, you should do operation of “Setting frame zero point
manually” again at the last frame zero point.
If the frame has been moved after power off, or if power on again after maintenance, you
should do again the operation of “Setting frame zero point manually”.
Operation:
(1)
Press "
" key, the menu appears as follows:
BECS-328 Computerized Embroidery Machine's Manual
54
