Chapter 23 Adjust the Machine’s Braking(for New Machine)
SET MACHINE PARAS
①SPEED AFTER TRIM: 80
②SPEED WHEN TRIMMING: 80
③HOOK ANGLE BY MOTOR: -92
④RATIO OF HOOK MOTOR: 1:9
NEEDLES: 6
⑥SET BRAKE PARA.: 5
⑦MAIN MOTOR PARA.: 0
⑧SET RUN SPEED: 80
⑨STARTUP STITCHES: 1
ARROW：MOVE， ENTER：CONFIRM
⑩STATUP ACCE: 15
(4) Press “
”to select “SET BRAKE PARA” and then press
“
”
.
(5) Press "
"or"
"to adjust the parameter value. (When the stop position is less than
100
°
, increase the value. When the stop position is larger than 100
°
, decrease the value. )
(6) Press
“
”
to confirm the setting.
23-2-2 Setting the Parameter "MAIN MOTOR PARA"
This parameter is effective only when the main shaft motor is electromagnetic motor.
This setting is use for adjusting the match of the main motor and the mechanical parts. The
range of the parameter is form 0 to 30, which default value is 0. During braking, if the main
shaft wobbles, quivers, or turn around, you should increase the value. If the main shaft spins
too fast, you should decrease the value.
Operation:
(1)
Press "
" key and the menu appears as follows:
OTHER MANAGEMENT
ARROW
：
MOVE
，
ENTER
：
CONFIRM
⊗
SET DESIGN PARAS
②FRAME TO POINT
③DESIGN RANGE,S OPERATIONS
④OFFSET
⑤SET POWER RESUME/ZERO POINT
⑥POWER RESUME
⑦SET MACHINE PARAS
⊗
COMPENSATION
⑨
中文/ENGLISH/SPANISH
⑩TO SET CYCLIC EMB.
(2)
Press "
" or numeric key "7" to move the cursor to "SET MACHINE PARAS", and
BECS-328 Computerized Embroidery Machine's Manual
89
