Chapter 5
Settings of
Embroidery Parameters
Owner’s Manual of BECS- A15 Computerized Control System
39
3.
Press
to finish the setting.
5.2
Instruction on Some Functions within General Parameters
There are brief descriptions of parameters in the appendix 1. Here, we will introduce
some functions mainly used in embroidery.
5.2.1.
Cyclic Embroidery Function
This function is to increase the embroidery productivity.
When the parameter “To Do Cyclic Emb.” is set as “Yes”, the cyclic embroidery
function is activated and the icon
will appear in the main interface. If this function is
activated, the machine will automatically embroider the patternsated patterns again without
any operation when completing it.
Usually, cyclic embroidery should accompany repetition embroidery and specially made
patterns, and the parameter “Auto Origin” should be also set as “Yes”. Thus when the
machine is embroidering the back fabric, the front one can be replaced. After embroidering
the patternsated patterns, the frame will automatically return to the start point and the machine
will automatically embroider the front fabric again and at this time it’s possible for user to
replace the back one.
5.2.2.
Brake Adjustment (A Must for New Machine)
This function is to adjust the control parameters for braking, so as to fit machines with
different mechanical characters, which is also able to change with the machine running. Thus
this function can help the machinery parts to work better with the computer. The function
depends on the parameters “Set Brake Para”.
“Set Brake Para” is to adjust the stop position of the main shaft. When the main shaft
often stops at the position below 100 degree, the user can increase the parameter value. When
the main shaft often stops at the position over 100 degree, the user can decrease the parameter
value. Thus the user can adjust the value to let the main shaft stop close to 100 degree. The
value can be set between 0 and 30.
After adjusting this parameter, the user can click the task swift key on the panel to return
to the main interface. Click
and
to make the adjustment and check the
effects of the parameter adjustment. If the user is not satisfied with the effects, he can press
the swift key on the panel to return to the parameter setting interface, where he can adjust the
parameter setting again. Close the parameter setting interface in the end.
