Chapter 10 About JF Sequin Embroidery
Owner’s Manual of BECS- A15 Computerized Control System
73
5.
Sequin-feeding method and the feeding angle can be changed via the
operation panel.
Ⅲ
. Specifications
1.
Size of Sequin available: Diameters at 3mm, 4mm, 5mm, 6.75mm and 9mm
；
2.
Max speed at 1000rpm.
10.2 Embroidery Procedure of Sequin
At sequin embroidery, user needs to follow the procedure at below:
1
．
Input design with sequin code, refer to 10.3
2. If necessary, please transform and edit the design, please refer to 10.4);
3. Set the sequin parameter according to the setting instructions in 10.5.
4. Check and adjust the sequin-feeding device (Refer to 10.8), so as to make sure the
sequin-feeding device works normally;
5. Set color-changing order (Refer to
10.6)
6. Return to main interface and confirm the embroidery;
7. Start embroidery.
Attention: during the embroidery, don’t dial the manual switch for moving the valve, or it
will cause the damage of the sequin-feeding device.
10.3 Input Sequin Design
Press
in the design management to enter disk selection interface to open the
disk needed. After selecting design for input, user needs press
to “Whether support
multiple gold or not”, choosing “
” is to save it as the special sequin design no matter
what is was. For the normal sequin designs, the changed sequin designs will save all the
multi-sequin within the original design as “A” type sequin. If you choose “
”, normal
sequin designs remain as they are, while special multi-sequin designs will be saved as special
multi-sequin design.
