Chapter 10 About JF Sequin Embroidery
Owner’s Manual of BECS- A15 Computerized Control System
81
This is to set gap number. If there is no gap, then it should be set to 0.
16.
L/R Sequin Valve Action Time
This parameter is for setting the response time at adjusting the valve action. The larger
value means the longer response time. Please set it according to the actual condition of device.
Default value of it is 2.
17.
L/R Trimmer Action Angle Adj.
This parameter is used at the special sequin device that uses motor to cut the sequin for
adjusting the start time of the sequin-cutting motor. The default value of it is 15. The smaller
value means the earlier action of motor, the range of this value is 0~31.
10.6
Manual Operation of Sequin Embroidery
The manual operation part contains “Sequin Start”, “Sequin End” and “Sequin-feeding”.
(1) Click
for selecting “sequin start” to let all the presser feet get down;
(2) Click
for selecting “sequin end” to lift all the presser feet;
(3) Click
for selecting “send sequin”; the activated machine heads will send a
sequin at each clicking (with presser foot at down position).
10.7
Debugging Multi-Sequin Embroidery
Location of Sequin Switch Board
1. Operation of Sequin Switch
(1) Manual Operation for Front Motor Sending A Sequin
Put the sequin switch to the down position, dial the thread-breakage detection switch to
turn on the green indicator and press manual sequin-feeding button.
