Chapter 12
Taping Embroidery
90
Owner’s Manual of BECS- A15 Computerized Control System
4.
D31 Rod Pos. of ZIG: Left/ Right
The “ROD POS. OF ZIG” determines the position of swing rod when M axis is in origin.
This parameter must be set in accordance with actual mechanical position.
5.
C38 Swing Value of ZIG
（
0
～
10
）
The parameter is for Z5 embroidery and applies to thick cords. For thick cord embroidery,
at Z5 embroidery, the system moves the frame to compensate the swinging scope of the lever.
6.
D42 Rotary Gap of M Axis: 0~10
The M axis of special embroidery head has mechanical gap, so it will generate the
mechanical difference after M axis changes rotating direction repeatedly. At embroidering the
flat tapes, if the shape of tape is curve and the M axis has no angle compensation, the needle
will fall at the edge of the tape instead of the right position at each turning.
Adjusting this parameter value is to ensure that the needle falls in the center of tape.
During machine debugging, parameter value should be “0” when needle falls in the center of
tape. If not, please repeat the adjustment to realize the best effect.
Generally, this parameter should be managed by professional experts before leaving
factory.
7.
D44 M Axis Work OFF Angle: 0, 90
In normal and sequin embroidery, if this parameter is set at 0, the M axis will stop at the
horizontal position; if it is set at 90, the M axis will stop at the vertical position. When the
distance between the normal embroidery head and special embroidery head is small, this
parameter must be set as 90° to avoid crashing.
8.
D39 Z Shift Control Angle: 0~180
When the rotating angle is larger than the set value, the Z axis will wing faster.
9.
D41 Adj Zig Rod Angle: 1~3
It is the starting angle of the rod, which indicates the relative position of the needle bar
and thread. It is used for adjusting the embroidery quality. “1” means the swing starts at an
early angle; “2” means the swing postpones certain angle; “3” indicates the swing postpones
certain angle again and starts.
10.
C36 Ratio of Coil Emb. (The ratio of coiling) : “1~4 Sti/L”
