Chapter 4
Common Parameters
and Color-Changing Order
Owner’s Manual of BECS- A15 Computerized Control System
29
Chapter 4
Common Parameters and Color-Changing Order
In this system each pattern has its own settings of the normal parameters (like scale and
repetition) and color-changing order. When a new pattern is selected, the corresponding
settings of normal parameters and color-changing order will become effective.
In this chapter, we will discuss the setting of the most frequently used parameters and
color-changing order, in parameter setting interface (
) and needle bar
color-changing order setting interface (
).
Since this system supports multi-task operation, user can set and modify the normal
parameters and color-changing order of the patternss that are not embroidered at present. User
can enter these operations via other operation interface under pattern management (see
Chapter 6).
4.1
Settings of Common Parameters
These common parameters include: “Direction”, “Angle”, “Scale X/Y”, “Prior Mode”,
“Rep. Mode”, “Rep. Order”, “Rep. Times”, and “Rep. Interval”. User can control the final
embroidery results by adjusting these parameters.
Press
to enter parameter setting interface:
