Chapter 10 JF Type Sequin Embroidery
BECS-D19 User’s Manual
111
Chapter 10 JF Type Sequin Embroidery
10.1 Sequin Embroidery Introduction
Sequin embroidery is formed by sequins and stitch forms. We need choose those hard
materials with smooth surfaces as the sequins. With the sequin in different color, size and shape,
embroidery will be shining and have amazing effect. Pattern with Sequin codes has its own
format.
A. Application Scope
This control system of sequin embroidery combines normal embroidery head, special
embroidery head and sequin-feeding mechanism.
B. Function Features
1.
Two ways of sequin feeding: Roller Type and Lever Type;
Roller: the core part in the whole mechanism is a wheel-like device. Its operating
principle is to rotate continuously in one direction so as to feed sequins into position.
Lever: the core part is lever type device. Its operating principle is to use the retrieval
movement of the linkage to feed sequins into position.
2.
Separate action of sequin appliqué and sequin feeding device;
3.
Manual separation of heads or collective sequin-feeding at one time;
4.
Separate display of sequin embroidery work status;
5.
Sequin feeding mode and angle can be modified via control panel.
C. Specifications
1.
Sequin diameter range: 3mm, 4mm, 5mm, 6.75mm, 9mm;
2.
Max. rotation speed: 850rpm
10.2 Embroider Sequin
User can make sequin embroidery by the following procedures:
1. Input pattern with sequin code, See 10.3;
2. Set sequin embroidery paremeters according to the following instructions, See 10.4
3. Check and adjust sequin feeding device, See 10.5, to ensure the normal work status;
4. Return to the main interface and confirm the embroidery;
5. Pull bar to embroider.
Note: do not touch air valve switch during embroidery, or it may cause damage to the
sequin feeding device.
10.3 Input Sequin Pattern
Press
in the main interface, to enter the “disk selection” interface, where user need
select the target disk and target pattern, and press
to enter the “pattern input” interface,
