Chapter 10 JF Type Sequin Embroidery
BECS-D19 User’s Manual
113
(1) Speed Limit for Left (Right) Sequin
The speed limit is determined by the sequin size. However, due to different mechanical
structures, even for sequin with the same size, the motor rotation angle will be different, which
is directly related to the maximum speed of sequin embroidery.
Note: the max. rotation speed of flat embroidery should be higher than that of sequin
embroidery.
Setting method: move the cursor to this parameter and press
to enter, and then press
or
to modify its value and press
to confirm.
(2) Left (Right) Sequin Feeding Angle Adjustment (range: -15~+15)
It is used to adjust the sequin feeding angle opposite to the main shaft. The higher the
value, the later the feeding time is.
(3) Sequin Embroidery Auto Start
When set as “Yes”, system will start sequin embroidery automatically; when set as “No”,
in case of sequin embroidery, user need pull bar to start.
(4) Sequin Device Lowering Time
This parameter is used to set the time from sequin device lowering to sequin embroidery
start (range: 0-15, default: 2). In case of air valve drive, default value is ok, but, for motor
drive, user should set as 4-5.
(5) Auto Lift after Thread Breakage
When set as “Yes”, sequin presser foot will automatically lift in case of thread breakage,
when set as “No”, manual operation is needed to lift the sequin presser foot after thread
breakage.
(6) Independent Action of Sequin Device
