Chapter 10 JF Type Sequin Embroidery
BECS-D19 User’s Manual
115
once to make all working heads to feed one sequin (with presser foot down);
(3) Press
in the main interface, move the cursor to “sequin end” and press “
”
to confirm; at this time, all presser feet will go up.
2. Separate Manual Operation:
Thread-breakage switch is embroidery switch. When it is at the down position,
neither flat embroidery nor sequin embroidery is available.
Thread-breakage warning lamp is mounted on the sequin sending device, which is
convenient for the operator to monitor.
Note: when the manual control switch of air valve is in the middle, blue lamp is on, which
indicates a normal condition of sequin embroidery.
Installation Position of Sequin Switch Board
10.6 Sequin Applique
After thread breaks or user manually turns on the red lamp, pulling bar will have the
machine return to sequin applique status. All the sequin devices will go up; machine stops
when it backs to the patch point. User can pull bar again to let the patch sequin device go down
for applique. When it reaches the thread-breakage point, machine stops, then other sequin
devices will go down to continue normal embroidery. “Patch stitch number” in machine
parameter setting is ineffective in sequin applique.
