Chapter 11 Coiling, Taping and Zigzag Embroidery
122
BECS-D19 User’s Manual
Press
in the main interface and move cursor to “pressor foot down”. Then press
“
” to display the dialogue window, where user can press “
” to lower the presser foot
or press “
” to quit the operation.
11.5 Special Embroidery Debugging
Debugging special embroidery mainly includes Zigzag swing to its origin and test of
presser foot action. Press
in the main interface, then move cursor to “Machine Test” and
press “
” to enter the management interface of machine test.
1. Zigzag Swing Rod to 100
°
Move cursor to “zigzag swing rod to 100
°
” and press “
”. Following the hint in the
dialogue window, user can pull bar switch to swing once or press “
” to quit the
operation.
2. Taping Presser Foot Action
Move cursor to “taping presser foot action” and press “
” to display the dialogue
window. Following the hint, user can pull bar switch to lift/lower the presser foot or pull it
again to lower/lift the presser foot, or press “
” to quit the operation.
11.6 Special Embroidery Procedure
(1) Input pattern: select, change or edit pattern according to need;
(2) Modify parameters, and select color-changing order and special embroidery mode;
(3) Check special embroidery head: ensure its normal work status;
(4) Pull bar to embroider.
11.7 Mechanical Device Category and Drive Mode of Special
Embroidery
Taping embroidery machines have three sets of the motion parts mechanically: M axis, E
axis and presser foot axis. M axis rotates by a certain degree at every stitch to trace the stitch,
which ensures cords or tapes always in front of needle movement. E axis swings once at every
one or two stitch to make the Zigzag embroidery. Presser foot axis is used for lifting and
lowering the presser foot.
1. M Axis
