Appendix 4 Loop Embroidery Parameter List
156
BECS-D19 User’s Manual
speed. Only effective for Dahao servo driver.
F35
Main Shaft Slow
Speed
80
80~150
Set the rotation speed of slow action of main
shaft when pull bar, by increment of 10 rpm.
F39
Velocity at Start
5
1~10
The larger the value, the faster the speed of
main shaft accelerates after start.
F40
Main Shaft
Motor
Parameter
0
0~30
Whenever value increases by1, brake more by
50ms.
F42
Pre-brake Angle
0
0~150
Applied to machine with servo at common
position. When speed down before stop,
default value of main shaft angle is 0,
corresponding angle is 335°; each time the
value increases by 1, the pre-brake angle
returns by 0.18°. The smaller the angle, the
more reliable the stop, but the lower
efficiency.
F62
H-axis Looping
Angle
Compensation
2
0~10
Larger value can improve stitch quality, but
may increase the probability of motor
over-load.
F63
H-axis Looping
Action Angle
5
0~10
F64
H-axis Looping
Thread
Returning
Compensation
5
0~10
F65
Speed Down at
Turning
2
1~9, No
Trimming Related Parameters
F01
Jump and
Trimming
7
1~7 stitches
trimming,
no
trimming
No: jump at jump code, auto stop, loosing
thread, moving frame, and auto start again;
Yes: when jump stitch number is smaller than
set value, jump without trimming, otherwise,
over frame at jump code, that is, auto stop,
trimming, moving frame, and auto start again.
F07
Thread
Treatment after
Trimming
Front
Front,
Back,
Simple
Thread residue is at fabric front, which can
prevent thread falling out.
F13
Thread
Treatment at
Color-changing
and Trimming
Yes
No, Yes
This parameter is used together with “thread
treatment after trimming”. When set as “Yes”,
same effect with F07.
F25
Trimming
Auto
Auto,
Manual,
Shut
In case of color-changing or over-frame and at
embroidery end, machine will trim according
to user’s setting.
Sequin Parameters (Chained Sequin for Reserve)
F79
Sequin Mode
Roller
, lever
Roller
single
sequin,
Select chained sequin mode.
