Chapter 2 Operation Guide
BECS-D19 User’s Manual
17
assistant embroidery interface. Please note: before using this function, user need preset
the origin of the frame. To set the frame origin, press
to enter other assistant
management operation.
6.
Set cyclic embroidery – press
to enter system parameter management interface.
Move the cursor to “Assistant Embroidery Parameter” and select parameter B02 for
parameter setting of cyclic embroidery.
D. Embroidery Confirmation
1.
Press
after finishing assistant operation. Then press “
” at the appearance of
the following hint window. Then
(embroidery release) will change into
(embroidery confirmation), which indicates that the system has enter embroidery
confirmation status.
If user press “
”, the system will remain in the embroidery release status. At
this time, even though user pulls the bar, the machine will not work and the system will
display the hint for user to confirm the embroidery.
2.
Start elsewhere
After confirmation of embroidery, if needed, press
to set another start point
following the hint. (Note: when embroidery starts, this setting is invalid.)
3.
Set color-changing and starting method
Under the main interface, press the position where the icon
(or
,
)
