Chapter 2 Operation Guide
18
BECS-D19 User’s Manual
locates to shift among
(auto color-changing, auto start),
(auto
color-changing, manual start),
(manual color-changing, manual start).
4.
Set normal embroidery or idling
Under the main interface, press the position where the icon
(or
,
)
locates to shift among
(normal embroidery),
(low-speed idling) and
(high-speed idling).
E. Pull the Bar to Embroider
Operation bar (embroidery bar) is under the table.
1.
Stop Status:
Pull the bar to right to start embroidery (including low-speed idling and
high-speed idling)
Pull the bar to left to return (including low-speed idling and high-speed idling)
2.
Running Status
At normal embroidery, pulling the bar to the right end is to embroider slowly and
releasing the bar will resume the normal speed.
Pulling the bar to left is to stop embroidery (including low-speed idling and
high-speed idling).
F. Manual Operation
1.
Manual trimming
When the machine stops, press
in the main screen. Follow the prompt and
select a trimming mode (“trim upper & bobbin” or “trim bobbin”). Then press “
”
to trim, or press “
”to exit trimming operation.
2.
Manual frame-moving
When the machine stops, press the keys
（
“
”
）
to move the frame
in the corresponding direction. Press the neighboring two keys at the same time to move
the frame in the direction of the angle bisector. “
” is the speed key for manual
frame-moving, to shift between
(high speed) and
(low speed).
3.
Clear the frame coordinates
When the machine stops, press “
” then press “
” to clear the XY
displacements displayed in the main screen. The function can be used with manual
frame-moving.
