Chapter 2 Operation Guide
22
BECS-D19 User’s Manual
statistic method and send out warning. Though it can almost avoid False Negative, it is not as
sensitive as the spring-type.
For the mixed type method, these two detection methods can complement each other with
their advantages, which results in sensitive and stabilized detecting effect.
No matter which method you use, there is one switch and one status light on each machine
head. There are three positions to switch but only two positions can be locked. When you
switch to the down position, status light does not shine, which means the head stops
embroidering. When you switch to the middle, status light is green, which means the head is
now in normal embroidery. In case of thread-breakage, machine stops and status light on that
particular head turns red. System automatically changes to patching mode on that head. If you
want to set a single head to patching mode manually, you can switch to the upper position,
which can not be locked. When you release the switch, it returns to the middle. Meanwhile,
status light on this head will turn red to indicate that patching mode is available on this head.
2.12 Working Status
The machine has three working statuses:
1. Preparation status
- preset parameters; choose embroidery patterns and perform
other preparation works;
2. Embroidery confirmation status
- confirm the parameter settings to enter the
quasi-running status;
3. Embroidery running status - embroider the pattern.
How to shift among the above working statuses?
In preparation status (
is displayed), after selecting embroidery pattern from the
memory and setting the parameters, user needs press “
” and “
” to enter embroidery
confirmation status (
is displayed). User should pull the embroidery bar to right to
embroider, which means the machine is in embroidery running status (
is displayed).
In embroidery running status (
is displayed), pull the bar to left to stop, and now the
machine is in embroidery confirmation status (pull the bar to right again and the machine goes
into embroidery running status).
In embroidery confirmation status (
is displayed), first press “
” and then press
“
” to release embroidery confirmation status. Now the machine enters preparation status
(
is displayed).
