Chapter 4 Memory Pattern Management
BECS-D19 User’s Manual
37
4.2 Select One or Several Patterns
Before any operation on patterns, you must select the target patterns. You can select one
pattern or select several patterns at a time to improve efficiency.
1. Press “
” to select targets
By default, the first item in the page is the selected one. Press “
” key or
directly use the pattern number key to select others. The icon and words of the selected target
appears within the blue squares.
During selection, if system is in multi-selection mode, user can select several objects.
2. Select several patterns in order
In multiple-selection mode, user can press “
” or the pattern number key to
select target item and press “
” to confirm selection. Repeat the process to select more. Or
you can press “
” to cancel the selection.
4.3 Select Pattern for Embroidery
1. Select a new pattern for embroidery and make sure system is in preparation status
.
2. In the main interface, press
to enter memory pattern management interface.
3. Select the pattern for operation in the pattern image area of the memory pattern
management interface.
4. Press “
” to enter modification interface of memory pattern parameter setting.
There are 30 parameters relating to the pattern, some of them can only be modified after
the administrator password is released. The setting method of it is the same as other parameter
setting procedure. Please refer to 5.2 for details.
5. After changing the pattern parameter, press “
” to confirm the pattern for
embroidery. If the operation is completed, system will close the memory pattern screen to
return to the main screen.
4.4 Pattern Preview
The selected pattern can be previewed in the memory pattern preview interface according
to the preset way, to check details of the pattern.
