Chapter 4 Memory Pattern Management
44
BECS-D19 User’s Manual
the dialog box, hinting “Set applique?”
5. If user chooses to move the frame out to the offset position, press
in the
dialog box, hinting “To Offset position?”. If the frame-out is at the fixed distance, firstly press
in the dialog box, hinting “To Offset position?”, and then press
to
set the moving-out distance: (2cm to 99cm) or (-2cm to -99cm).
6. Repeat steps 4 & 5, to set all the appliqué positions of the pattern.
7. Press “
” to save the appliqué information or press “
” to cancel operation,
system will return to the pattern operation selection interface.
4.8 Satin Stitch Compensation
This operation is to adjust the satin stitch width in the pattern according to need.
1. Press
in the main interface, to enter memory pattern management interface.
2. Select the target pattern in the pattern image area of the memory pattern management
interface.
3. Press “
” to enter satin stitch width adjustment interface.
4. If user doesn’t want to use the default value, press “
” to change it with keyboard.
5. Input the value of “satin stitch X (Y) compensation” and press “
” to confirm.
6. Press “
” to adjust the satin width and save it as a new pattern or press “
” to
cancel the adjustment operation, system will return to the pattern operation selection interface.
