Chapter 5 Machine Parameter Management
54
BECS-D19 User’s Manual
Chapter 5 Machine Parameter Management
In this system each pattern has its own settings of the normal parameters (like scaling and
repetition) and color-changing order. When a new pattern is selected, the corresponding normal
parameters and color-changing order that are saved with the pattern will become effective.
This system supports multi-tasks at the same time. So it’s possible to set or change the
normal parameters and color-changing order of patterns not under current embroidery. The
entrance for the operation of those patterns is at the corresponding operation interface under the
memory pattern management interface (See Chapter 4).
Press
in the main interface to enter the following interface:
As the picture shows, when you move the icon to certain parameter, system will show
some parameters (4 at most), and press “
” to enter the interface for setting that parameter.
5.1 Common Parameter Setting
Common parameters include: “X&Y Scaling”, “Rotating Angle”, “Direction”, “Priority
Mode”, “Repetition Mode”, “Repetition Priority”, “X&Y Repetition” and “X&Y Interval”.
User can control the final embroidery results by adjusting these parameters. That’s why these
parameters are often adjusted when a pattern is selected.
In the embroidery preparation status “
”, press
in the main interface and then
“
”to enter the common parameter setting interface.
