Chapter 5 Machine Parameter Management
BECS-D19 User’s Manual
57
5.1.5 Repetition Mode
Currently, system supports normal repetition and part repetition. Normal repetition
means: after embroidering a pattern, system will embroider the same pattern again; part
repetition is based on color, system will move to next color after finishing embroidering one
color in all the patterns.
5.1.6 X-Y Repetitions
X Repetitions set the number of rows in repetition, and Y Repetitions set the number of
columns in repetition. The above diagram shows that X Repetitions is 3 and Y Repetitions is 2.
The largest set value is 99*99.
5.1.7 X-Y Repetition Interval
The above diagram also explains the meaning of this parameter.
5.1.8 Priority Mode
There are two modes: rotating priority and scaling priority. When user has selected the
“Rotating Priority”, the pattern will rotate first and then scale up/down according to the set
parameters. Otherwise it will scale up/down first and then rotate.
5.2 Setting of Other Embroidery Parameters
Other parameters include 8 groups: embroidery assistant parameters, thread-breakage
detection parameters, frame parameters, main shaft parameters, thread-trimming parameters,
sequin parameters, special embroidery parameters and machine configuration & maintenance
parameters. For machines with encryption function, some parameters can be attached with
administrator password or factory password. For setting the administrator passwords and the
factory password, as well as initialization of parameters, please press
to enter the
