Chapter 5 Machine Parameter Management
60
BECS-D19 User’s Manual
5.2.2 More Functions for Setting Other Parameters
There are brief introduction of parameters in the Appendix 1. Here are some functions
used in embroidery.
1.
Cyclic Embroidery
This function can increase the embroidery efficiency.
When the parameter “To Do Cyclic Embroidery” is set as “Yes”, the cyclic embroidery
function is activated and the icon
will appear in the main interface. When this function is
valid, after completing the embroidery of a selected pattern, the machine will automatically
embroider it again without pulling the bar.
Usually, cyclic embroidery accompanies repetition embroidery or specially-designed
patterns, and the parameter “Back to Origin after End” should be also set as “Yes”. Thus when
the machine is embroidering the following cloth-piece, the previous one can be replaced by
user. After embroidering the selected pattern, the frame will automatically return to the start
point and the machine will automatically embroider the previous cloth-piece again and at this
time it’s possible to replace the following one.
2.
Save Manual Color-changing
In embroidery confirmation status, user can choose whether to save the manual
color-changing’s needle position into the color-changing order unit. Its purposes are as follows:
1) if mistakes are found at the automatic color-changing order during embroidery, the
color-changing order can be modified with manual color-changing; 2) when a new pattern is
embroidered with manual color-changing once, the color-changing order is set for the pattern.
To use this function, user should set the parameter “Save Manual Color-changing” as
“Yes”. Note: the parameter value will automatically change into “No” at the end of embroidery
of one pattern.
3.
Brake Adjustment (A Must for New Machine)
This function is to adjust the control parameters for braking, to adapt to machines with
different mechanical characteristics, which may also change along machine running. Thus this
function can help the machine to work better with the computer. The function depends on two
parameters “Stop Position Compensation” and “Main Motor Parameter”.
To adjust the parameter “Stop Position Compensation” is to adjust the stop position of the
main shaft. When the main shaft often stops at less than 100 degree, user can increase the
parameter value. When the main shaft often stops at more than 100 degree, user can decrease
the parameter value. Thus user can adjust the value to let the main shaft stop close to 100
degree. The value range is between 0 and 30.
To adjust the parameter “Main Motor Parameter” is to adjust cooperation between main
shaft motor and mechanical parts. The parameter value can be set between 0 and 30, and set as
0 in most situations. If during braking the main shaft vibrates without moving or rotates in the
reverse direction, or looks like lacking of brake strength, user can increase the parameter value.
After adjusting these parameters, user can press the task swift key on the panel to return to
the main interface. Press the key
and “
”, to check the effects of the parameter
