Chapter 5 Machine Parameter Management
BECS-D19 User’s Manual
65
5.5 Initialize Machine Parameters
This function can initialize the general embroidery parameters of the machine. System
saves a group of default parameter values. The manufacturer and embroidery factory
administrator can save their parameter settings. This operation need follow the rules at below:
1. When the manufacturer password and embroidery factory administrator password are
not set or the machine has no encryption function, all general embroidery parameters are
initialized to their default values.
2. When that manufacturer password has been set and unlocked, all general embroidery
parameters are initialized to their default values.
3. When that manufacturer password has been set and still locked but administrator
password has not been set or has been released, all manufacturer-authorized machine
parameters are recovered to the values saved by the manufacturer and other parameters are
initialized to the default values.
4. When both manufacturer password and administrator password have been set and still
locked, all manufacturer-authorized machine parameters are recovered to the values saved by
the manufacturer, all administrator-authorized machine application parameters are recovered to
the values set by administrator, and other parameters are initialized to their default values.
5. When that manufacturer password has not been set and administrator password has
been set but unlocked, all general embroidery parameters are initialized to their default values.
6. When that manufacturer password has not been set and administrator password has
been set but still locked, all administrator-authorized machine application parameters are
recovered to the values saved by administrator and other parameters are initialized to the
default values.
5.6 Save Machine Parameters to Disk
This function is to save the current software information and machine parameters to disk
for future inquiry or use.
5.7 Read Machine Parameters from Disk
This function is to read data from disk to machine, in order to make use of saved
parameters at any time necessary without reseting them.
5.8 Adjust XY Parameters of Servo Frame
This type of parameters is used for the machine whose main shaft uses Dahao servo motor
and driver. Only the manufacturer can modify these parameters. For machine with encryption
function, you must input the manufacturer password before adjusting the parameters or
performing the corresponding operation to the machine. The operation process is as follows:
1. Press
in the main interface.
