8.Features
© China Daheng Group, Inc. Beijing Image Vision Technology Branch 107
Region0 setting
The Region
0 cannot be closed. If the user wants to change the parameters of the Region0, in the “image
format” option and pull-down menu of “Region selection”, select the “Region0”, then change the image
width, image height, horizontal offset and vertical offset.
Region1 setting
The Region1 can be set as open or close. If the user wants to close the Region1, just select “Region1” in
the pull-
down menu of “Region selection” in the “image format” option, and select “Off” in the pull-down
menu of “Region Switch”. When the Region1 is closed, setting the image width, image height, horizontal
offset and vertical offset will not have any effects.
If the user wants to open Region1, just select “Region1” in the “image format” option, select “Region1” in
the pull-
down menu of “Region selection “, and select “On” in the pull-down menu of “regional switches”.
When the Region1 is opened, setting the image height, image width, and horizontal offset and vertical
offset will enable the camera to output the image of the corresponding region.
Region2 setting
The Region2 can be set as open or close. If the user wants to close the Region2, just select “Region1” in
the pull-
down menu of “Region selection” in the “image format” option, and select “Off” in the pull-down
menu of “Region Switch”. When the Region2 is closed, setting the image width, image height, horizontal
offset and vertical offset will not have any effects.
If the user wants to open Region2, just select “Region2” in the “image format” option, select “Region2” in
the pull-down
menu of “Region selection”, and select “On” in the pull-down menu of “regional switches”.
When the Region2 is opened, setting the image height, image width, horizontal offset and vertical offset
will enable the camera to output the image of the corresponding region.
Region3 setting
The Region3 can be set as open or close. If the user wants to close the Region3, just select “Region3” in
the pull-
down menu of “Region selection” in the “image format” option, and select “Off” in the pull-down
menu of “Region Switch”. When the Region3 is closed, setting the image width, image height, horizontal
offset and vertical offset will not have any effects.
If the user wants to open Region3, just select “Region3” in the “image format” option, select “Region3” in
the pull-
down menu of “Region selection”, and select “On” in the pull-down menu of “regional switches”.
When the Region3 is opened, setting the image height, image width, and horizontal offset and vertical
offset will enable the camera to output the image of the corresponding region.
8.2.3. Switching Acquisition Mode
Trigger mode supports two options:
ON
and
OFF
. When trigger mode is set
OFF
, the camera works in
continuous mode; when trigger mode is set
ON
, the camera works in trigger mode. It can be switched
between
ON
and
OFF
any time after the camera is opened.
As shown below, switching the acquisition mode at different positions will have different results.
Switch acquisition mode during frame reading out
