TBM
PILOT’S OPERATING HANDBOOK
700
SECTION 4
NORMAL PROCEDURES
EASA Approved
Page 4.3.28
Edition 1 -- November 30, 2010
Rev. 0
CHECK--LIST PROCEDURES
AFTER STARTING ENGINE (1/2)
1 -- ”GENERATOR” selector
-- On ”MAIN”
Voltage and current checked
. . . . . . . . . . . . . . . . .
when battery current
≤
50 amps :
-- on ”ST--BY”
Voltage and current checked
. . . . . . . . . . . . . . . . .
(reset if necessary)
-- then again on ”MAIN”
2 -- ”AVIONICS” MASTER switch
ON
. . . . . . . . . . . . . . . . . . . . . . . . . . .
3 -- ”AP TRIMS” MASTER switch
ON
. . . . . . . . . . . . . . . . . . . . . . . . . . .
4 -- PFD 1, MFD and PFD 2
-- Brightness
ADJUST
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If necessary
-- DISPLAY BACKUP button
CHECK
. . . . . . . . . . . . . . . . . . . . . . .
then return to NORMAL mode
If battery current < 100 A :
5 -- ECS panel
-- ”BLEED VALVE” switch
ON (LO or HI)
. . . . . . . . . . . . . . . . . . . .
-- ”CABIN FAN” switch
As required
. . . . . . . . . . . . . . . . . . . . . . .
-- ”FREON” or “AIR COND” switch (if installed)
As required
. .
-- ”CABIN TEMP” selector
ADJUST
. . . . . . . . . . . . . . . . . . . . . . . .
-- ”DEFOG / NORMAL” distributor
AS REQUIRED
. . . . . . . . . . . .
Cabin altitude selector
Airfield altitude - 500 feet
. . . . . . . . .
Cabin rate selector
ARROW UPWARDS
. . . . . . . . . . . . . . . . . .
(at the halfway post)
6 -- Stand--by instruments
CHECKED
. . . . . . . . . . . . . . . . . . . . . . . . . . .
-- Suction gage
CHECKED
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7 -- ADI/HSI on PFD1 / PFD2
CHECKED
. . . . . . . . . . . . . . . . . . . . . . . .
8 -- Altimeter setting
CHECKED
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .