TBM
PILOT’S OPERATING HANDBOOK
700
SECTION 4
NORMAL PROCEDURES
EASA Approved
Page 4.4.48
Edition 1 -- November 30, 2010
Rev. 0
AMPLIFIED PROCEDURES
CLIMB (1/2)
1 -- Power lever
ADJUST according to
. . . . . . . . . . . . . . . . . . . . . . . . .
engine operation table -- Chapter 5.7
to MXCL indicator on the PFDs
CAUTION
OBSERVE TRQ / Ng / Np / ITT / T
°
AND OIL PRESSURE LIMITATIONS. USE OPTIMUM
TORQUE AND / OR REFER
TO TABLES IN CHAPTER 5.7
Torque setting during climb must be adjusted according to engine
operation tables in Chapter 5.7. These tables give the max. climb
power torque setting (MXCL). For each engine, when torque is
reduced below 100 % at high altitude according to the tables, the
ITT will be approximately constant during final climb, giving a
particular value of ITT. For a simplified engine operation during
climb, power may be set first of all by torque, using 100 %, then,
when the ITT typical value for climb is reached, by indicated ITT,
using this particular value.
2 -- Climb speed
AS REQUIRED
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Best climb speed is 123 KIAS. Performance tables concerning
climb at 130 and 160 KIAS are given in Chapter 5.9.