SECTION 4
NORMAL PROCEDURES
EASA Approved
TBM
700
PILOT’S OPERATING HANDBOOK
Page 4.5.15
Edition 1 -- November 30, 2010
Rev. 0
PARTICULAR PROCEDURES
UTILIZATION BY COLD WEATHER (-- 0
˚
C to -- 25
˚
C) AND VERY
COLD WEATHER (-- 25
˚
C to -- 40
˚
C) (9/10)
ENVELOPE 2
The procedures defined for the ”envelope 3” are also applicable for the
”envelope 2”. However it is possible to start the engine using GPU
without
preheating of the engine and the cabin
with a heater. In that case the
procedure ”After starting the engine” is modified as follows :
Preflight inspection / Before starting the engine / Starting the engine
Apply the procedures defined for the Envelope 3.
After starting the engine
1 -- ”ECS” panel
As soon as the current flow is lower than 100 A :
-- ”BLEED VALVE” switch
ON
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-- ”CABIN TEMP” selector
FULL HOT
. . . . . . . . . . . . . . . . . . . . . . . . .
Preheat the cabin respecting time defined in Figure 4.5.2 before
switching on the navigation and monitoring systems. This allows to
respect minimum temperatures necessary for the equipment
operation.
2 -- Propeller governor lever
As soon as the oil temperature is greater than 0
°
C :
-- Propeller governor lever
MAX. RPM
. . . . . . . . . . . . . . . . . . . . . . . . .
-- Perform 2 propeller regulations
3 -- Apply normal procedures defined in Chapter(s) 4.3 and / or 4.4.