Manual Dry Motoring 2 / 2
► Continuing
If ignition symptoms occur (ITT increasing):
14 - STARTER switch ............................................................................ OFF
Dry motoring sequence is stopped.
End of procedure ■
After 30 seconds maximum:
15 - STARTER switch ..................................................................................... OFF
16 -
STARTER
................................................................................... Check OFF
17 - Engine crank mode ................................................................................. OFF
To deactivate the engine crank mode, press again the
crank mode button in the dedicated GTC sub-menu
NOTE
It is recommended to avoid more than two consecutive motoring between two
engine starts, to minimize potential leakages of the bearing #1 lab seal.
End of procedure.
Pilot's Information Manual
Section 4
Normal Procedures
PIM TBM 960 - Edition 0
Rev. 01
Page 4.4.27
PIM - DO NOT USE FOR FLIGHT OPERATIONS