NOTE
The AUTO mode is recommended in order to obtain the best temperaure
regulation in both cockpit and cabin areas.
By pressing the CABIN CTRL pushbutton on the ECS panel, the pilot can override
the cabin settings and apply the cockpit settings to the cabin area. Then, the cabin
touchscreen control panel displays "PILOT IN CONTROL". To give the control
back to passengers, the pilot can press again the CABIN CTRL pushbutton. The
cabin touchscreen controller then returns to the previously selected settings, and
passengers can modify them as required again.
NOTE
The cabin touchscreen control panel also allows passengers to control cabin or
baggage area ambient lighting.
In case of windshield or side windows misting, the pilot can press the DEFOG
pushbutton. The ECS controller will command the HAD to divert hot air towards
the windshield and side windows for 10 minutes.
Cabin Touchscreen Control Panel:
In the cabin zone, passengers can set the cabin temperature and fan speed on the
touchscreen control panel.
Emergency Air System:
An emergency ventilation valve allows outside air to enter the cabin when the
EMERGENCY RAM AIR control knob is pulled out. The EMERGENCY RAM AIR
control knob is located under the right side of the instrument panel, near the right
control wheel.
-
In the NORMAL position, the valve is closed and the control is locked.
-
To open the emergency ventilation valve, press the locking button on the
knob and pull out.
NOTE
Reduce the cabin differential pressure to be able to pull out the EMERGENCY
RAM AIR control knob. If necessary, depressurize the cabin.
System Protection
Power for the ECS is supplied by the BUS 2 bar and is protected by the AIR
COND breaker.
Section 7
Description
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 02
Page 7.10.11
PIM - DO NOT USE FOR FLIGHT OPERATIONS