The table hereafter gives the status light colors corresponding to the state of the
system.
System state
Status light
OFF
ON (AUTO mode)
ON (MAN mode)
Heating of Pitots and Stall Warning Sensor
The two pitots, which supply ADCs and the standby instrument, and the stall
warning sensor are electrically heated. This deice equipment must be used even
during flight into non-icing conditions.
The system is operated by the PITOT L/R & STALL HTR switch.
The system condition messages
PITOT NO HT L
or
PITOT NO HT R
,
PITOT HT ON L
or
PITOT HT ON R
,
STALL HEAT ON
or
STALL NO HEAT
are displayed in the CAS window. Refer to the Garmin Pilot's Guide for further
details.
NOTE
Correct operation of the audible stall warning may be altered by severe or
prolonged icing.
Turbine Air Inlet Protection
Operation and description are detailed in
Paragraph Engine Air Inlet in Subsection
.
Section 7
Description
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 00
Page 7.14.5
PIM - DO NOT USE FOR FLIGHT OPERATIONS