WARNING
Make sure the lanyard pin is inserted into the correct check valve
for the mask that is being installed. If pins are cross-connected,
lanyard cords pulled by passengers will initiate oxygen flow to
another mask.
8. Insert lanyard pin into the corresponding check valve.
9. 9. Place the mask in the deployment container with facepiece first. Make
sure that the oxygen tubing and lanyard cord are free to deploy and are not
caught between the container and the lid.
10. Close and latch deployment container lid.
BatteryMINDer Charger
See
CAUTION
Carefully read the charger manufacturer’s instructions prior to use.
The charger shall be used only on the ground.
The charger is not designed to be permanently installed on the airplane.
Never charge a battery that is frozen or is at a temperature above 51 °C (123
°F).
CAUTION
Make sure that the Quick-Disconnect connector (3) is connected to the battery
(4) before setting the BatteryMINDer charger's power.
1. Pull down the crash lever.
2. Pull the BATT BUS breaker located in the front cargo compartment.
3. Remove the cap (1).
4. Connect the BatteryMINDer charger connector plug (5) to the airplane
connector (2).
5. Connect the BatteryMINDer charger (6) to the electrical mains with the plug
(7).
6. Begin the operations according to the charger's instruction manual.
7. After use, disconnect the BatteryMINDer charger plugs (7) then (5), put the
cap (1) back on the connector (2) and push the BATT BUS breaker located
in the front cargo compartment.
Section 8
Handling, Servicing and Maintenance
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 00
Page 8.7.13
PIM - DO NOT USE FOR FLIGHT OPERATIONS
