background image

6

1

en

 

Instructions

IMPORTANT! 

Read the operating and safety instructions 
BEFORE placing the document shredder 
into operation. 
You must follow the instructions.
Keep the operating instructions in a safe 
place ready for later use.

Table of Contents

Important information  . . . . . . . . . . . . . . . 6

1.4  Scope of supply . . . . . . . . . . . . . . . . . .   60
1.5   Technical specifications  . . . . . . . . . . . . . 60

Operation . . . . . . . . . . . . . . . . . . . . . .   61

2.4   Paper shredding   . . . . . . . . . . . . . . . . .   62
2.10  CD, DVD & card shredding . . . . . . . . . . . . 64
3  

Maintenance / troubleshooting  . . . . . . . . 66

3.1   Emptying shredding waste . . . . . . . . . . . . 66
3.4  Overheated . . . . . . . . . . . . . . . . . . . . . . 67
3.5  Overload . . . . . . . . . . . . . . . . . . . . . . . . 67
3.15  Cleaning the shredder . . . . . . . . . . . . . . . 70

1.1   Intended use, warranty

The document shredder is intended to be used for 
shredding paper.
Depending on the model variant, a small amount of 
the following materials can also be shredded:
-  CDs/DVDs, bank cards and credit cards (see techni-

cal data).

-  The normal staples and paper clips found in paper 

documents (exception: security level P6 and P7 
devices).

Wear, damage due to improper use or unauthorised 
modifications and repairs are not covered by the 
warranty or the guarantee.

The document shredder was designed for private use 
and for use in normal office environments.

The following conditions apply to the performance in 
terms of sheets listed under technical data:

Maximum number of sheets that are shredded in one 
pass under the following conditions: New cutting roll-
ers, oiled if needed, cold motor, power supply with 
nominal voltage and nominal frequency (230 V/50 Hz;  
120 V/60 Hz). Deviations may result in reduced sheet 
processing and increased operating noises. The sheets 
are fed centrally and lengthwise at a 90 degree angle. 
The performance in terms of sheets can also vary 
depending on the paper properties and input.

1.2   Safety instructions

-  Do not place the device near a source of heat.
-  Store, transport and operate the device in an 

upright position only.

-  Only use liquids and gases on the device that com-

ply with DAHLE guidelines.

-  Do not open up the device.
-  Only operate the device in closed spaces, at 

temperatures of between 10 °C and 25 °C (50 °F 
to 77 °F) and at a non-condensing humidity of 
between 15% and 95%.

-  Ensure that the building installation has short-

circuit protection: max. 16 A (US max. 20 A).

-  Do not operate the document shredder without 

inserting documents.

-  The device is not intended for use by persons 

(including children) with restricted physical, 
sensory or mental capabilities or a lack of experi-
ence and knowledge, unless they are working 
under supervision or receive detailed instruction 
about how to use the device from a person who is 
responsible for safety.

Dispose of the document shredder 
properly in an environmentally friendly 
way at an authorised collection point. Do 
not dispose of any parts of the document 
shredder or packaging in domestic waste.

Summary of Contents for ShredMATIC 35120
















Reviews: