Filter Reset
7
Remove the water tank
Put in the new filter and press the
lever until hearing the "click" sound
After closing the top cover,
place the water tank
Open the top cover
Open the filter handle
Lift the old filter
3. As shown below:
①
Follow the steps shown below to replace the filter.
②
After replacing the filter, hold the Filter Reset button for 3 seconds to reset the filter life.
Product Parameters
For the technical improvement of the product, the following parameters are subject to change
without prior notice, please refer to the nameplate of the product.
The purified water flow rate is tested when the environment temperature 25±2°C and water
temperature 25± 1°C.
Rated voltage/ frequency
Rated hot water capacity
Rated power
Rated total purified water amount
Purified water flow
Inlet water pressure
Working pressure
Applicable water quality
Applicable ambient temperature
2500L
220-240V~ 50/60Hz
≥90
°C, 20L/h
DT-WP-22
2190W
Model
0.2L/min
0.05-0.1MPa
0.45-0.8MPa
Municipal tap water
4-38°C
Water treatment process diagram
Municipal tap water→Integrated composite filter→PP sediment filter→Fiber activated carbon
→Nanofiltration membrane→Activated carbon rod→Water output
Waste water
→
Service guide
3 seconds
Applicable water
Tap water
TDS ≤350 ppm
Summary of Contents for DT-WP-22
Page 12: ...The product is subject to change without notice Please keep this manual properly...
Page 24: ...Produkt nderungen vorbehalten Bitte bewahren Sie diese Bedienungsanleitung sorgf ltig auf...
Page 48: ...Il prodotto soggetto a modifiche senza preavviso Conservare con cura il presente manuale...