EN
59
The V-Clamp Hinge
There are a several versions of the V-Clamp. Instructions on adjusting
the V-Clamp are provided below. Please check your bike to determine
which V-Clamp version is used and apply the appropriate instructions.
See the different versions below, and how to differentiate them.
Adjust the hinge bolt so that the hinge opens and closes with the
correct amount of force which is 39~88 N for aluminum frames.
NOTE:
Adjust in 1/16-turn increments only, otherwise you will quickly
over-tighten or over-loosen the V-Clamp hinge.
WARNING: If the hinge is over tightened the tension can
cause damage to the frame.
Hinge clamp on the frame’s back
half.
Open the hinge to adjust.
Use an 8 mm wrench to adjust.
VERSION A
Hinge clamp on the frame’s front
half.
Open the hinge to adjust.
Use an 8 mm wrench to adjust.
VERSION B
Hinge clamp on the frame’s front
half. The adjustment nut is on
the outside. A 6 mm Allen key is
needed to adjust it.
Open the hinge before adjusting it.
The lock nut needs to be loosened
with a 10 mm wrench.
VERSION C
Lock Nut
