Local Configurations
171
Figure 5-141
Configure the settings for the parameters of drawing rules. See Table 5-46.
3)
Parameter
Description
Name
Enter the customized rule name.
Action
Configure the actions that are defined as intrusion. You can select
the
Appear
check box and the
Cross
check box.
Direction
In the
Direction
list, select the direction of crossing the configured
area. You can select
Enter&Exit
,
Enters
, and
Exits
.
Filtering Target
Click
to draw areas to filter the target.
You can configure two filtering targets (maximum size and
minimum size). When the target that is crossing the tripwire is
smaller than the minimum size or larger than the maximum size, no
alarms will be activated. The maximum size should be larger than
the minimum size.
Preset
In the
Preset
list, select the preset that you want to configure the
rule for.
Table 5-46
Drag to draw an area.
4)
Click
OK
to save the settings.
5)
Click
to set the actions to be triggered. For details, see "5.11.1.1 Configuring
Step 3
Select the
Enable
check box, and then click
Apply
.
Step 4
Summary of Contents for DH-5208AN-4KL-X-8
