Local Configurations
167
Parameter
Description
Filtering Target
Click
to draw areas to filter the target.
You can configure two filtering targets (maximum size and
minimum size). When the target that is crossing the tripwire is
smaller than the minimum size or larger than the maximum size, no
alarms will be activated. The maximum size should be larger than
the minimum size.
Preset
In the
Preset
list, select the preset that you want to configure the
rule for.
Table 5-44
Drag to draw a tripwire. The tripwire can be a straight line, broken line or polygon.
4)
Click
OK
to save the settings.
5)
Click
to set the actions to be triggered.
Step 3
The
Trigger
interface is displayed. See Figure 5-138.
Figure 5-138
Configure the triggering parameters. See Table 5-45.
Step 4
Parameter
Description
Period
Click
Setting
to display set interface.
Define a period during which the alarm linkage is active. For
details, see "Setting Motion Detection Period
” section in "5.10.4.1
Summary of Contents for DH-5208AN-4KL-X-8
