Local Configurations
227
Table 5-64
Compile the two MIB files by MIB Builder.
Step 3
Run MG-SOFT MIB Browser to load in the module from compilation.
Step 4
On the MG-SOFT MIB Browser, enter the Device IP that you want to manage, and then
Step 5
select the version number to query.
On the MG-SOFT MIB Browser, unfold the tree-structured directory to obtain the
Step 6
configurations of the Device, such as the channels quantity and software version.
5.16.1.10 Configuring Multicast Settings
When you access the Device from the network to view the video, if the access is exceeded, the
video will not display. You can use the multicast function to group the IP to solve the problem.
Select
Main Menu > NETWORK > MULTICAST
.
Step 1
The
MULTICAST
interface is displayed. See Figure 5-197.
Figure 5-197
Configure the settings for the multicast parameters. See Table 5-65.
Step 2
Parameter
Description
Enable
Enable the multicast function.
IP Address
Enter the IP address that you want to use as the multicast IP.
The IP address ranges from 224.0.0.0 through 239.255.255.255.
Port
Enter the port for the multicast. The port ranges from 1025 through
65000.
Table 5-65
Click
Apply
to complete the settings.
Step 3
Summary of Contents for DH-5208AN-4KL-X-8
