Local Configurations
262
Figure 5-242
Configure the settings for the security parameters. See Table 5-73.
Step 2
Parameter
Description
Type
In the Type list, you can select Limits of network-whitelist, Limits
of network-blacklist, or Updata time-whitelist.
Enable
Enable the security settings.
Start Address
Enter a single IP address or a start IP address of a network
segment.
Add IP Address
Click
Add IP Address
to add a single IP address.
End Address
Enter the end IP address of a network segment.
Add IP Segment
Click
Add IP Segment
to add the IP addresses from the start IP
through the end IP.
The system supports up to 64 IP addresses.
Table 5-73
Click
Apply
to complete the settings.
Step 3
5.20.2.2 Configuring System Service Settings
You can enable or disable the system internal services.
Select
Main Menu > SYSTEM > SECURITY > System Service.
Step 1
The
System Service
interface is displayed. See Figure 5-243.
Summary of Contents for DH-5208AN-4KL-X-8
