23
Figure 3-4 Installation 3
Important
Please note Figure 3-4 is based on non-IR series camera. For IR series product, the lock screw
position and the lens angle adjustment are the same.
Step 7
Line up the dome camera protection enclosure and follow step 4 backward to put enclosure back.
Installation is completed.
Note
Usually we recommend, after the installation, please take the three white static protection gaskets from
the accessories bag and insert them to the screw holes of the protection enclosure. It is to enhance
device reliability.
3.2.2 Manual Zoom Lens Focus Operation
The manual zoom lens focus interface is shown as in Figure 3-5.
Step 1
Slightly loosen the adjusting screw E and push the adjust screw E to make it swing. Adjust the lens
focus to the proper position according to the displayed video.
Step 2
Slightly loosen the adjusting screw F and push the adjust screw F to make it swing. Adjust the lens to
get the clear video and then fix the adjusting screw firmly.
Step 3
Lock Screw A
Adjust lend horizontal
rotation angle.
Lock screw B/C
Adjust lens vertical
rotation angle.
Lock screw D
Adjust lend
horizontal rotation
angle.