100
Figure 4- 95
4.7 Alarm
Here you can set WEB monitoring alarm type and alarm sound only if you enable alarm upload
function. Please see Figure 4- 96.
In alarm type, select alarm event, check to enable event. When there are event checked, you can
view alarm info below. In operation, you can check listen alarm and prompt. In alarm sound,
check sound pop-up and you can select sound.
Figure 4- 96
Type
Parameter
Note
Event
Type
Video Loss
When video is lost, it alarms.
Motion Detect
When motion detect is ON, it triggers alarm.
Disk Full
When disk is full, it triggers alarm.
Disk Error
When disk error occurs, it triggers device alarm.
Video Mask
When video is masked, it alarms.
Operation Listen Alarm
Web subscribes alarm type checked above, when device
alarms, it will notice WEB, and WEB will prompt user.
Open Video
When alarm occurs, the system will auto enable video
monitoring, and this is for alarm of alarm detection type, as
motion detect, video loss and video mask.
Summary of Contents for DH-M70-D-0204HO
