22
Figure 3- 3
Network Mode: It includes multi-addresses, fault tolerance, load balance, net bridge and
link aggregation.
Aggregation Set: Under net bridge mode under.
Net bridge Set: Under net bridge mode only. This setup can bind any two network cards
to one net bridge as one network card can only bind one net bridge. Bound net bridge
will be shown in Ethernet dropdown box. Bound network card as net bridge will be not
shown.
Ethernet Card Name: You can select from 1~~2.
Default Ethernet port: You can select from 1~~2. Under multiple addresses and bridge mode
only.
Aggregation strategy: Under aggregation link mode only. Strategies available are MAC-
address-based, IP-address-and-port-based, IP-address-and-MAC-address-based. IP-
address-and-port-based.
IP version: IPv4 and IPv6.
Summary of Contents for DH-M70-D-0204HO
