31
4 Web Operation
4.1 Network Connection
Before web client operation, please check the following items:
Step 1. Network connection is right for the device and PC.
Step 2. PC network setting is right, including IP address, subnet mask and gateway. (If there is
no router in network, then allocate IP address in same net section. Otherwise, set gateway
and subnet mask.)Please refer to Chapter 3: main menu
setting
network.
Step 3. Use order ping ***.***.***.***( IP address) to check connection is OK or not. Usually the
return TTL value equal to 64.
Step 4. Set Internet Explorer: Tools-Internet Option-Security-Custom Level. Enable or prompt
ActiveX and plug-in. IE7 and IE8 are preferred.
Step 5. Open the IE and then input IP address.
Step 6. It pops up security box asking you whether you accept webrec.cab control unit, please
select “accept”, and system will start to install.
If system forbid this download, please check if there is other plug-in blocking the download
and meantime lower IE browser security level.
Note:
When device upgrades new program, and before you open WEB, you must delete original
control unit and then open WEB.
To delete control: go to C:\
Program Files and select “webrec” folder.
4.2 Login
Figure 4- 1
Open IE and input address in the address field. For example, if your IP is 10.43.200.141, then
please input http:// 10.43.200.141 in IE address field and press enter. Please see Figure 4- 1.
Summary of Contents for DH-M70-D-0204HO
