Dahua IR Thermal Imaging Network Camera Web3.0 Operation Manual
65
5.3.5 Alarm
Please note some series products do not support this function.
5.3.5.1 Alarm
Figure 5-37
Parameter
Note
Enable
Check the box to enable relay activation.
Working
Period
It is to set the alarm period, it can enable alarm event only in the set time range.
There are six periods every day for setup and you must check box in front of
each period to enable it.
Select days (Sunday by default, if select all the week, then it means applying
the setup into the whole week; you can also check the box in front of the day
and make setting for some days separately).
Click “OK” button after completing setup, go back to motion detect setting page,
click “OK” button to finish working period setup of motion detect
Note: Period setup can be done by dragging mouse while not releasing left mouse.
Anti-Dither
System only memorizes one event during the anti-dither period. The value ranges
from 0s to 100s.
Sensor Type
Able to set NC and NO.
Record
System auto activates motion detection channel to record once alarm occurs
(working with motion detection function). Meanwhile users have to set record period
of alarm in “Storage>Schedule” and select auto record in the record control
interface.
Record Delay
System can delay the record for specified time after alarm ended. The value ranges
from 10s to 300s.
Summary of Contents for DH-TPC-BF5300
